New reports not showing up on the report page, but scans still run

[Ae2P]

Hey,

I am using the container installation variant and ran into a problem.

My scheduled tasks still run; they show up in the logs as finished, they send me the email report but they do not show in the web interface under Scans > Reports.

Under Scans > Vulnerabilities (translated) new vulnerabilities still are being created.

But I do not see any new report under Scans > Reports.

Until ~1 week ago everything was running fine, no changes have been made.

On the troubleshooting page it says to run:

docker exec -u gvmd greenbone-community-edition-gvmd-1 gvmd --rebuild-gvmd-data=all

But I receive:

md main:MESSAGE:2025-12-11 11h43.42 utc:6128: Greenbone Vulnerability Manager version 26.12.1 (DB revision 262)
md manage:MESSAGE:2025-12-11 11h43.50 utc:6128: Rebuilding configs from feed…
md main:WARNING:2025-12-11 11h43.50 utc:6128: Failed to rebuild gvmd data: No configs feed directory.
Failed to rebuild gvmd data: No configs feed directory.

I also tried to pull the containers again, but to no avail.

No filter is set on the reports page.

Any tips?

[rippledj (Joseph)]

Just a quick note that I have moved this thread to the correct category: Community Containers

[rippledj (Joseph)]

The troubleshooting section you are referencing is related to report configurations provided by the COMMUNITY FEED, not reports generated by your scans.

Also, I’m curious - did you see any errors when trying to pull the containers again? Were they they same or different than when you tried to rebuild the gvmd data? Can you describe your installation setup? Do you have enough free disk-space?