Cannot Scan Vmware Workstation Host IP

Hello, I downloaded and installed 4.3.14 in Vmware Workstation Pro 12.
Networking is set to bridged and tried replace physical network state checked and even unchecked.
I can scan all other host on my subnet but cannot scan the local host that Vmware and GCE run on.
Scan comes up empty.

Is this by design or can anything be done?

Thank you

This is a issue of your local hypervisor, i suggest you check your virtual network setup and debug this. It´s not a GOS issue. To debug just connect both VMs back to back with a host only network, if this works it´s a issue with your switch / Ethernet port.

1 Like