Can't create a scan config (failed to find config)

Archive Greenbone Community Edition
42

@dresc
So I’ve followed all of the same steps here, but I ran into an issue with the last two commands here.

The first one says that there is a syntax error in the setting value, but it works when I try my userid

the second command says scanner not found, but it works when I use the openvas default scanner id

but even after I run those commands, I still get the same error when I try to scan.

Any Thoughts?

43

Hi @cfi

Thanks again for the support, I’ll save these links, in case I need to solve this problem again in the future.

:blush:

1 Like
44

Hi, @SirScotty

This case I reproduced, exactly the same commands that @filo performed in some interactions in this post, above! Did you get to see them? It was on Mar 21, his second post.

45

For the solution what I found was:

Go to Administration - new User and create a new user with administrator role.

I close session I stop the service:
sudo gvm-stop
start the service:
sudo gvm-start
you access with the new user and ready you can create your tacks.

PD.: My english is bad.